I would like to mount the switch for my Grizzly G0442 Dust collector inside the shop and will run power to that via conduit from a junction box on the wall but I would then like to pass the power cable from the switch to the motor through the wall to the DC closet I built without going through a pair of junction boxes. I am imagining just passing a piece of 3/4 conduit through the wall connected to two wall plates with cable compression fittings but I'm coming up short finding compression fittings that will connect directly to conduit. All the ones I have found at the borg are meant to connect to a junction box.

Looking for ideas, recommendations or alternatives to make this work without cutting the stock cable.