OK, finally got the floor down for the new shop, and ready to start placing tools. Have budgeted plenty of room in middle for a double table saw setup, with my Powermatic 66 with a Beisemeyer 52" fence being the main saw, and an older delta cabinet as one dedicated for dadoes and the like. My question, and I'd love to hear input, I am having trouble deciding between a side by side layout, with the delta off the right side of the P66 or one where the Delta is back to back. If I go this side by side route, going to have to rework the existing shopfox mobile base, since the right side is setup for light fence support only, not a heavy saw. Or I could leave the P66 alone, and then put the Delta on the back side of it, going opposite direction. I have plenty of room to lead wood into each one (10' in either direction currently, obviously that might change as something gets added). There's always a give/take, just not sure what I'm giving...
Have been out of the ww for quite awhile, and just now getting back into it, so I know I'm not thinking thru all that I need to consider. Since it's been awhile, I can't remember what I can't remember, or is it don't know what I don't know?
Appreciate any input, and pictures are extremely appreciated if possible. TIA!! Dave