Saw this Milwaukee 16x24" Alum. framers square advertised as a new tool on Toolnut for only $25. I got one. I dont like others abusing my accurate squares. I put it up against my Woodpeckers, and they were Nutz-on registered to each other. I was quite shocked. I would have thought a few thou out since it is quite a long run of 24". But nope, dead on. I might have got a good sample, or, maybe CNC machining, even on the low end products are damn good these days. Its not as robust as the Woodpeckers, but much thicker than I would have thought...did I mention it was $25?
Mw.jpg20190919_151857.jpg