FastCap sells a brush like material that is fastened to a flexible roll. It is peel and stick. I wonder if that would complete your setup, allowing less dust to escape around the blade.
They sell it to install around CNC router setups. Looks like the brush part is about 1 1/2 to 2" tall.
I saw it about two years ago, and assume they still have it.
PS: Looks like you made a nice zero clearance insert. Care to share more pics of it, or did I miss that while I was gone.
Last edited by Rick Potter; 10-13-2019 at 11:40 PM.
Rick Potter
DIY journeyman,
FWW wannabe.
AKA Village Idiot.