Results 1 to 13 of 13

Thread: ULS owners - help ? advice on wood over-burn ?

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 09-11-2019, 3:42 PM #1
    Mike vonBuelow's Avatar
    Mike vonBuelow
    Mike vonBuelow is offline [OP] Member
    Join Date
    Oct 2010
    Location
    NorCal
    Posts
    369

    ULS owners - help ? advice on wood over-burn ?

    I belong to a makerspace here in Sacramento, and using a 60w laser. I'm getting wood burn, which I think is an air assist problem, and slow exhaust, but the owner says 'it's normal'

    Anyone have similar experience? Fixes?

    The air assist is a ULS, and I was told that the software controlls the air input - is there a way to trick it into providing more air ?

    I would like to avoid having to mask, or do clean-up afterwards

    T.I.A.
    Attached Images Attached Images
    Mike

    Proud 24-yr USAF Veteran

    COMPUTER: Dell Optiplex 620 - XP
    LASER HARDWARE: Pinnacle 25W Mercury,     LaserPro 50W Explorer
    SOFTWARE: Corel X3, CS4 Suite, Photoshop Web Suite CS3, Solidworks
    FIRMWARE: My brain

    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules