Results 1 to 5 of 5

Thread: Bosch PR20EVSPK Router Issue

  1. #1
    Join Date
    Jul 2016
    Location
    Lebanon, TN
    Posts
    352

    Bosch PR20EVSPK Router Issue

    So I was using my Bosch Palm router, for the first time, with a 1/4" spiral up cut bit.

    I needed to cut a square hole out of a 3/4" piece of plywood. I figured I'd make two or three passes, adjusting the depth on each pass.

    I could not get the base to clamp tight enough to stop the bit basically pulling the motor down inside the exterior base. I adjusted the 8mm lock nut that is on the clamping mechanism, as tight as I could get it, but still be able to use the toggle eccentric clamp.

    Any one else had a similar issue. or have suggested solution?


  2. Not specifically with a spiral cut but, but I have noticed it vibrates up or down with other cutters.

  3. #3
    Join Date
    Mar 2006
    Location
    SoCal
    Posts
    19,675
    I’ll have to look at mine but, with the fine height adjustment threads engaged this should not be possible, yes?
    Buy a man a plane ticket and he’ll fly for a day.
    Push a man out of a plane
    and he’ll fly for the rest of his life.

  4. #4
    Join Date
    May 2007
    Location
    Trinidad, West Indies
    Posts
    402
    Base has to be twisted to lock in position IIRC.

    This is prior to doing fine adjustment.

    MK

  5. #5
    Join Date
    Jul 2016
    Location
    Lebanon, TN
    Posts
    352
    Quote Originally Posted by Mikail Khan View Post
    Base has to be twisted to lock in position IIRC.

    This is prior to doing fine adjustment.

    MK
    Thank you, I guess I should have read the manual.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •