Just inherited an old Delta Rockwell 46-525 lathe from my dad. It had a spur center and a live center for the tail stock but I was hoping to get a drill chuck for hollowing out bowls and vases. The issue is the insert for the tail stock on this lathe is not a morse taper but a solid ram. I can’t find anything that would allow me to put a drill chuck into this stock. Am I stuck with only using the live center that came with it? Is there a way to adapt it? Do I need to try and find a newer replacement tail stock that takes MT2 accessories? Should I sell this thing and look for a newer lathe? Thanks for any advice.