Results 1 to 3 of 3

Thread: .OUD File

  1. #1

    .OUD File

    I am using Smartcarve and it outputs an .oud file for cutting.

    We produced a perfect rectangle in Smartcarve, but when cut the end result is not perfectly square. It is off by quite a bit.

    I was wondering if anybody here had Smartcarve and could try our file to see if it produces the same wonky result, or if it is just our machine?

  2. #2
    Join Date
    Jan 2015
    Location
    Washington state
    Posts
    232
    You might try creating a square using your machines native software, and cutting that, to prove that your machine is set up correctly. You may have to make adjustments to the step counts of the servos?
    Since you didn’t specify what machine you are cutting on, just throwing generic trouble shooting ideas out.
    Scott
    Rabbit Laser RL-60-1290, Rotary attachment, Corel Draw x6, Bobcad Ver 27
    Juki-LU 2810-7, Juki 1900 AHS, Juki LU-1508, Juki LH-3188-7, Juki LH 1182
    Sheffield 530 HC webbing cutter

  3. #3
    Explain 'not perfectly square' -- just in size, or shaped wrong, or both?
    ========================================
    ELEVEN - rotary cutter tool machines
    FOUR - CO2 lasers
    THREE - fiber lasers
    ONE - vinyl cutter
    CASmate, Corel, Gravostyle


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •