My shop currently only has two 30Amp 220v receptacles (single circuit) in the center of a 40x40 area, and a couple by the panel, and one in the corner.
Most of the equipment will be in the center near the receptacles, but there are not enough receptacles.
Should I..
1) add more boxes so they can all plug in?
2) Consolidate some breakers and create another circuit? (Will need to surface mount, as it is totally finished)
Should not need to run more than one item at a time, so I am leaning towards more receptacles on the same circuit.
With regards to power needs not near a jack, I'm not going to rip up the floor.. or buy a raised floor (I wish)
So what do you guys do.. use the walk over power runs?
Tim