Page 2 of 2 FirstFirst 12
Results 16 to 17 of 17

Thread: Cutting Railroad Rail?

  1. Recently cut a 4 foot section of rail out of a full (20 ft.) rail. Used a reciprocating saw - I used three blades to make both cuts ((one & one-half per cut) . LENOX blade outperformed all others. It took less than an hour. And this was at a remote site, on the ground kneeling with a cordless DeWalt saw (and 4 batteries).
    Last edited by Bohdan Pasemko; 12-16-2019 at 8:16 PM.

  2. #17
    In my metal working class someone cut a piece of rail with the horizontal bandsaw. As I recall it took quite a while.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •