OK, finally got funds and time, and thought i was good to go. I scored the delta 50-273 for the used Unisaw i got a couple of months back and then said i need the 50-284 extension as i have a 52" Unifence. However.....
My set up has the saw (20"), a left hand wing (10") and a 24" table with 2 legs that attaches to the right hand side. The extension is way too long and there doesn't seem to be an obvious shorter extension to go with my set up. But, maybe I'm missing something, you guys know way more than me.
Also, I started thinking, do I really need a base extension for the 24" table? I must roll the saw out of the way when not in use in my garage. I guess i could forget the table and get another wing, but wings aren't cheap and I have the table extension already, thinking i would like that setup.
I can put castors on the base legs, but that won't help when i engage the base, seems like using the mobile base will want to flex the connection of the table to the saw. Maybe it is not a big deal, but maybe it is.
I don't have the capability, but i guess the extension could be modified to work, a few cuts, a couple of welds.....
Thoughts appreciated.
Mike