[OP]
Contributor
I may have already asked this but can’t remember. Can I run my KF500 single phase Saw/shaper and my DC40 power feeder on the same 20a circuit? Saw sticker says 16.5A and the power feeder sticker says 2.3A.
Total is under 20 but I’m not sure how to interpret potential real power load of these two items if there are factors beyond these two numbers to consider. Thanks.
Contributor
Sure, I run mine on a 15 ampere circuit
A 20 would be just fine. Neither machine will be near full load, nor will the load factor be very high.
Regards, Rod.
[OP]
Contributor
Thanks. Saves me a few bucks this way.
Originally Posted by Rod Sheridan
Sure, I run mine on a 15 ampere circuit
A 20 would be just fine. Neither machine will be near full load, nor will the load factor be very high.
Regards, Rod.
Posting Permissions
Reply With Quote