Hi Folks. Its been a while since my last problem and I hate to have to be here asking. Has anyone ever had a problem opening EZCAD with a MFC application stopped working popup that prohibited the program from working. After having the scan head replaced I felt confident that this machine would be fine but here I am again with problems. I cant open the software and so my laser is non functioning once again. It is a Ray fine 30W MOPA with cyclops camera. I can open the software with the machine off and in demo mode so I suspect it has something to do with a hardware problem but hoping that I am missing something. All connections are good and up until today the laser was working flawlessly. Jim