Perhaps some of you can cast some light to one fact happened last week and I couldn't explain its reason.
I used my planer sledge to get some tapered legs for a project I am doing - actually I have made tapered cuts in the past but always using my table saw, it was the first time using my planer and its sledge. Please see the attached schematics.
Tappered legs.jpg
I used two supports, one 5 mm height and another one 10 mm. It looked me perfect except the planned surface is around a couple of mm convex!
I cannot figure why as the legs were attached to sledge with hot glue... perhaps the legs flexed at the middle?
Personally I liked the slightly convex legs and I prefer them as a boring straight one but it is disturbing do not understand why I got that. I am used with Geometry but I missed that - your input to explain that will be very welcome!
Thanks in advance for your help!