I've had a my own cabinet shop and a performax 22-44 for about 6 months. Previously I worked in high end cabinet shops with 36"+, 2-3 head wbs. The transition has been...eye opening. After spending the time to calibrate the head to be parallel my results have been acceptable save for one issue. My work pieces are constantly stalling mid pass leaving almost unnoticeable (until finish) chanels. I always have "hands on" because I can't trust the feed, this makes everything slower and I can't trust the results. I've adjusted feed rollers, belt tracking, depth of cut, speed of feed and have never gotten a single piece to make a pass without at least one pause. The work piece stops not the feed belt. Do I need a new feed belt? It still feels to the touch that it has plenty of abrasive. Is this a common issue? I can't find any information on troubleshooting the problem. Please help! I'm loosing valuable days in a 1 man shop.