Results 1 to 7 of 7

Thread: 6" Delta jointer with long table fence

  1. 07-02-2019, 1:19 PM #1
    Edward Gore
    Edward Gore is offline [OP] Member
    Join Date
    Jun 2019
    Location
    Hernando, MS
    Posts
    4

    6" Delta jointer with long table fence

    Anyone have any ideas where i could find a replacement fence for this old relic?
    Reply With Quote Reply With Quote
  3. 07-02-2019, 1:21 PM #2
    Matt Day
    Matt Day is offline Contributor
    Join Date
    Dec 2005
    Location
    West Lafayette, IN
    Posts
    6,530
    eBay or OWWM, but it might be a good excuse to upgrade.
    Reply With Quote Reply With Quote
  4. 07-02-2019, 6:47 PM #3
    Edward Gore
    Edward Gore is offline [OP] Member
    Join Date
    Jun 2019
    Location
    Hernando, MS
    Posts
    4
    Quote Originally Posted by Matt Day View Post
    eBay or OWWM, but it might be a good excuse to upgrade.
    I have spiral head jointer, but my dad gave me this one and I was thinking of making this one my primary and getting a shelix head for it, etc. Ive trolled ebay, but no luck thus far.. I will check OWWM out and see if I can score some parts, thanks!
    Reply With Quote Reply With Quote
  5. 07-02-2019, 6:51 PM #4
    glenn bradley's Avatar
    glenn bradley
    glenn bradley is offline Contributor
    Join Date
    Mar 2006
    Location
    SoCal
    Posts
    22,512
    Blog Entries
    1
    Model number or picture may help.
    "A hen is only an egg's way of making another egg".


    – Samuel Butler
    Reply With Quote Reply With Quote
  6. 07-03-2019, 10:10 PM #5
    Bill Dufour
    Bill Dufour is offline Contributor
    Join Date
    Sep 2016
    Location
    Modesto, CA, USA
    Posts
    9,979
    Im had a 6" jointer for years then I realized most of the drawers i made were between 6-8 inches tall. Since got the 8" jointer I keep most drawers under 8" tall. that works well for most stuff in the house. Some shop drawers are taller but I have kept them under 12" which is my planer width.
    Bill D
    Reply With Quote Reply With Quote
  7. 07-04-2019, 9:26 AM #6
    Mark Carlson
    Mark Carlson is offline Member
    Join Date
    Dec 2004
    Location
    Boston, MA
    Posts
    919
    Maybe you could fashion a fence out of a piece of aluminum extrusion.
    Reply With Quote Reply With Quote
  8. 07-04-2019, 9:37 AM #7
    Mike Kees
    Mike Kees is offline Member
    Join Date
    May 2014
    Location
    Alberta
    Posts
    2,162
    Which fence are you looking for (pics would help ). Is it the fence that locks at the end of the infeed table ?
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules