Anybody want to venture a guess on the maker of this massive 1" corner chisel? Next question: how do I put an edge on this thing?
IMG_8483.jpgIMG_8482.jpg
Anybody want to venture a guess on the maker of this massive 1" corner chisel? Next question: how do I put an edge on this thing?
IMG_8483.jpgIMG_8482.jpg
The bevel needs to be on the inside.
My first step would be to see if it is hardened by running a file over one of the inside edges.
for some reason it looks unhardened to me.
jtk
"A pessimist sees the difficulty in every opportunity; an optimist sees the opportunity in every difficulty."
- Sir Winston Churchill (1874-1965)
A carver or specialty woodworker would disagree with the bevel comment. Both inside and outside bevels are found. Depends upon use.
"A pessimist sees the difficulty in every opportunity; an optimist sees the opportunity in every difficulty."
- Sir Winston Churchill (1874-1965)
One picture is worth?
happen to have almost the same corner chisel....1" per side...
Big corner chisel 1.JPG
Big corner chisel 2.JPGBig corner chisel 3.JPG
3 photos = how many words....for a timber framers corner chisel?
Big corner chisel 3.JPG
1 photo and 4 words to interpret ; a blunt cutting edge on that corner chisel.
it is as found...haven't had the time to sharpen it ...yet, other than remove the rust.
OP was asking about the bevels on one of these....OP can then sharpen the chisel he has to suit....
So....a flat bevel? or, a Convex bevel.....or hollow grind the bevels...that be a question for yet another sharpening thread.
Last edited by steven c newman; 06-22-2019 at 4:42 PM.