I bought a Delta table saw 2nd hand about 2 months ago and it's been cutting boards fine...that is, until today when I attempted an 8/4 12" wide slab of maple that was given to me. I've been using a new thin kerf Diablo blade on the saw since I've had it so I kept the same blade for this maple slab. I checked the outlets to see if I tripped anything and nothing's been tripped. As far as the table saw motor, no smoke at all seen and no burned out smell either. I don't know the model number off hand but it's the $600 saw that's currently displayed at Lowe's. Any ideas or advice? Does anyone know this table saw better than me?