Short question are these good side mount slides? https://quikdrawers.com/drawer-slide...bearing-slides I am using blum under mounts in the same peace. If not what would be a good match?



I am building a vanity
20190606_072520.jpg
2 drawers on left and doors on the right side. The top long slot was just going to be a fake drawer front since the sink needs room. But now I would like to make it into a shallow U shaped drawer that fits around the sink. 3 inch tall and 34 wide with about 2 1/4 inch inside drawer height should be a good place for a lot of small stuff.
20190606_074936.jpg20190606_075039.jpg
How should I go about making the curved part of the drawer back? should I resaw and do a bent lamination I am going to use 1/2 inch for the bottom and screw the sides and back on top to maximize my space.