So... I walk mounted my delta dust collection (1.5hp), added Wynn filter, and added Super Dust Deputy. The outlet is a 5inch, so I will run a 5 inch main.
My problem, is that my table saw sits in the middle of the room. I see that most recommend the drop from the ceiling to come down the back, right side by the outfield table. I think I made a design mistake, but I added a router plate into my table saw. A drop in that location would probably get in the way when routing. I could run a pipe across the floor, but would like to avoid it if possible.
Does anyone have any experience like this or have any suggestions? I am paralyzed.
Thanks,
Adam
Also, 5 inch main and 5 inch drops to 4 inch flex hose, or 4 inch drops off the main?