Hi All,
I have the above listed lathe that I have had now for 4 years. It’s been a good lathe however over the years I have had to replace the Banjo, Digital Readout and now the tail stock has a 3/32” wobble so it is hard to line up the points. It frustrating. While this is one of their less expensive lathes, it was still a lot of money for me. I am playing around with different ideas to get rid of the wobble but if non of them work, then I am looking at $75.00 for a new tail stock body.
They’re tech support has been very helpful and professional. Always has been but it is very frustrating to have these kind of issues happen especially in a machine only 4 years old.
Anyone else with this lathe and if so have you encountered issues with it?
Jeff