I put a 3/4" blade on a Laguna bandsaw (18bx), and tried to have it track with the gullets in the center of the wheel. (Some folks say that reduces drift). But I can't get the blade that far back before the rear of the blade rubs on something (not sure what). Tracking as far back as I can, the cut is too wavy for making thin veneers.
Laguna's answer to my question was just to recommend their YouTube videos. Other ideas I tried were to increase the blade tension and to cut more slowly.
Is the advice to center the gullets on the wheel right?
Am I making some mistake in putting the blade on?
Are there other ways to improve the tracking and get finer, straighter cuts?