Vector cutting simple circles and rectangles testing out the Epilog radius.

Coreldraw 2018
Epilog Radius

I made some small ovals in coreldraw - RGB red, "hairline" pen. and one with a .007 pen
work are set to 24x18
in printer driver work area set to 24x18

The .007 oval raster etched,
The hairline vector cut but left a very small "Teet" on one side, easily snapped the oval out.

Then I made son hair line boxes, only 3 sides cut, it is leaving off the right side every time, no matter where I place the rectangles.
Watching the laser it cuts the top side, jumps down and cuts the bottom, then the left, but never the right.

Any ideas?

Nick