Hi Folks,
We are trying to get the IQ to run a simple program correctly.

The program locates 2 holes at:
X: 4.0 Y: 1.0
X: 4.0 Y: 10.0

We have an origin setup at the corner of the work piece. When we run the program it seems that the machine is offsetting the positive direction of both X & Y. The offset appears to be 1/4 per inch in each direction. So for the 4.0 X location we are about 1.0 inch offset. For the Y 1.0 we are offset .25 and for Y 10.0 we are offset 4.0 inches.

The display on the handheld however displays the correct location without the offset. The dimensions are expressed in mm.

We have looked at the actual program file and the dimensions are correct although in mm.

Anyone have any ideas?
Izzy