I am trying to quote on a job where I need to reverse engrave 450 4" x 2" (gemini clear matte/gold) and spray paint when engraved. The question I have is:
should I set up a matrix and engrave them all at the same time without vectoring out the actual size. Paint the entire sheet and then return to the laser and cut them out or do one at a time.
Another question is: is there a special paint I should be using? I tried this with Krylon for plastic and it seemed to be fine except for the smoking when I cut it out.
Lastly, I will need to apply adhesive tape so they can be mounted. I don't know if the adhesive will react to the paint?
Any input or suggestions would be greatly appreciated and what would be a cost to do the job, I am figuring $6.00 to $9.00 per plate.
I would be using a ULS 45w laser.
Rev eng painted.jpg
Forgive me if the pic didn't load properly.
Thanks for having a look -