[OP]
Member
Update: I just planed it down with a BU Jack, set the blade out a little farther than usual when planing end grain and put a lot of force into each stroke. Planed from both ends in to avoid splintering. Didn't take long at all. Thanks for all the great suggestions everyone!
Contributor
Getting it done!Originally Posted by Steven Mikes
By now doing it likely took less time than it takes to read this thread.
jtk
"A pessimist sees the difficulty in every opportunity; an optimist sees the opportunity in every difficulty."
- Sir Winston Churchill (1874-1965)
Posting Permissions
Reply With Quote