Anyone try using a router table as a scroll saw?

[Michael Costa]

I have a 1/16" bit (1/4" in height) and a 3/32" bit (3/8) in height).

Thoughts.

Screenshot_20190218-143410_Pinterest.jpg

On 1/4 or 1/8 Baltic Birch

[Rick Potter]

Only two thoughts. 1. I wonder how long the bit would last .
2. I suspect it would be much harder to follow the pattern with a router bit.

If you try it, let us know how it worked out.

[Peter Kuhlman]

I would use some mdf and make a replacement router plate and attach a quality jigsaw upside-down.
Won’t be capable of cutting quite as fine of curves or holes but blades are cheap and would last a long time.

[Matt Day]

That 1/16” bit will snap really quick.

[Osvaldo Cristo]

That 1/16” bit will snap really quick.

Very true. Try to work with the biggest bit you can. 1/4" probably will be the minimum robust solution. Use minor bit only at areas you really need them.

Although I am very careful I frequently broke 1/16 bit and it is the reason I have three of them in the shop...

[Robert Engel]

A jigsaw mounted upside down to a table can accomplish the same effect.

[Frank Pratt]

I think it would be almost impossible to accurately follow the line.

[Michael Costa]

I haven't tried and might on a piece of scrap for shyts and giggles. I'll be sure to wear my face shield so that tiny bit doesnt hurl itself into my eyes or jugular when it does snap.

[Jim Becker]

Michael, I've used cutters as small as 1/16" on my CNC and trust me, they are not for "through cuts" like you would typically do with "scroll sawing". You have to take tiny bites to insure that you don't put too much lateral pressure on them. There's not a whole lot of metal there to resist breakage. A "poor man's scroll saw" made with an inverted jigsaw and a small blade would likely last longer. That said, for that option, be really careful with safety as always is necessary when using tools.

[Rick Potter]

I would think the cheapest $50 scroll saw from Craig List would do an infinitely better job, without being the 'white knuckler' your router would be.

[George Yetka]

Also it may not be too safe

[Ben Rivel]

Man, if you try that, wear a full shield!