I'm hoping i didn't screw up so bad that i cannot recover.
I built this "built-in" years ago when i was building my first set of kitchen cabinets. The main kitchen turned out fine but i've been putting this project off for along time. Now the wife is after me to finish.
I really didn't think through this much at the time but had to get something into place so the granite could get installed.
So is there a hinge that will work here. I'd like to build inset doors. As you can see the plywood sides, which are in the same plane as the tigerwood, sit about 1/2" towards the center of the cabinet (yellow line) and the front to back measurement is about 3/4" (red line).
Any suggestions?
BTW in case it's not obvious my goal is to put drawers behind those doors. Looking back it sure would have been easier just to bump the drawer slides out rather than the entire sides but live and learn.