Stair Transition - Advice

[Chris Pembrook]

Thanks to everyone's advice I'm almost complete with my stair project. However, I'm left with the finishing stair nose transition. IMG_20190319_055612107.jpgIMG_20190319_055533333.jpg
I eventually will add hardwood to the landing but with the rounding edge of the plate in the second picture i can't get the stair nose to go completely across for a nice finish. Any advice appreciated.

Thanks.

[Chris Pembrook]

One thought i had was to run an oscillating saw on the plate to make room for the stair nose to slide under and go the full length of the stair.

[Kevin Jenness]

Can you do a jack miter? Make the stair nosing the same radius as the existing and run a small transition molding under them both.

[Richard Wolf]

You need a piece of landing tread. Cut the rug back and glue down a piece. If you need to lower it a bid you can reduce the thickness of the tread section to 3/8".

https://www.hardwood-lumber.com/red-...QaAuC9EALw_wcB

[Chris Pembrook]

Thanks Richard, do I need to do anything to get it under the white stair plate? The stair extends under it a bit and leaves a gap.

[Chris Pembrook]

I routed out the top a bit so it slide under. Finished product now!