Well, will see how this goes....already have had a few days start. Had a tall stack of resawn Ash, before all those trips to the Hospitals happened, and then the Chester Drawers Project....decided to clear the "decks" and see what I could build with the stuff...Sorted through, found 4 pieces that almost match each other, needed jointed
ash box start 1.JPG
Flipped them around a few times, to see how they matched up....I wanted 2 panels...
Ash Bos, 1st panel cleaned up.JPG
One has been glued up, allowed to cure, and then cleaned up..
Ash Box, 1st glue up.JPG
And this one came out of the clamps today...ends were sawn square, faces sanded and plane smooth and flat....
Ash Box, #3 clean up.JPG
2 shorter panels were also made...one has been cleaned up, #4 went into the clamps today.....
Also sorted through the stack of parts, looking for enough to make two lids..
Ash Box, 2 lids.JPG
Will get these jointed and glued up, later this week....decided to make a match set of two boxes...had to cross cut a few panels...
Ash Box, re-sized.JPG
The panel under these was also cut to make the sides of box #2. Maybe Tuesday, i can lay out for the finger/box joints, and start cutting those....by hand.
Stay tuned