Have ever broken a folding carpenter's rule?

[lowell holmes]

I have and when I do, I have a folding yard stick.
If you are working wearing a nail apron, you can carry it in one of your apron pockets.
I find it to be very handy.
Then you have an excuse to go buy another folding rule. I like the 96" rules.

I just ran across mine.

[Al Launier]

How many times? Each gets you a new rule!

[Tony Zaffuto]

Only my dad's, over fifty years ago. Never broke one of my own, though my wife did, and she had to make, maybe 3 purchases to get the correct (inside reading) rule!

[Bill Houghton]

No, but I've seen broken ones at yard sales, so, when I use mine - mainly for inside measurements - I'm right careful about how I open, use, and close it.

[Mel Fulks]

Not sure I've broken one ,but the broken ones I've seen usually have non straight grain that made a weak point.
I did fail to unfold a couple of segments once. Ruined a piece of walnut the boss had designated for a lowboy for his wife.
He had saved it for years and marked it for "low boy top". Those rules are only accurate when completely UNFOLDED !

[Jim Koepke]

If you mean what are often called zig-zag rulers, no none of mine nor my father's has ever broke in my use. They are not often used by me.

My favorite is a four fold 3' ruler.

jtk

[Kevin Hampshire]

I have never owned one of those folding rulers. My father had at least two of them that survived use/abuse by three sons.

I had the impression that those rulers never broke.

[James Pallas]

I witnessed a couple being broken, looking over my shoulder at the seat of my pants. I like them never broke one so far but have worn a few out over the years.
Jim

[Jim Koepke]

My most used 4-fold had the markings worn off. An extra fine point Sharpie helped to bring it back to a useable ruler. It has a SW Hart trademark, so it is at least 85 years old.

We should be so useful & limber when we are that old.

jtk

[lowell holmes]

I have a 72" ruler and I used to have a 96" one as well. When I was building houses, we needed the length because studs are 96". Also a carpenter can single hand
mark most cuts. Of course tapes will do that, but if you are marking header height on door framing, the 96" length is needed.

[steven c newman]

Ash Box, Lid parts 2.JPG
Making a couple box lids...needed to know how long to make the parts...
Ash Box, 2 lids.JPG
Parts are 3/8" thick Ash...

[Richard Jones]

Sure. All were Lufkin X46's. Had an 8' once, wouldn't fit in my hip pocket as easily. Table saw got hold of one once, not a pretty sight...........

All of my jeans had a hole in the left rear pocket, from removing/inserting those 'stick rules' a zillion times. Tape lines were for framers, not us snobby finish guys........

[Jacob Reverb]

I didn't know they would break ... my Dad's old Lufkins are all aluminum!

[Jack Frederick]

In the pipe traders I carried a Lufkin L46X for years. It had the hook and slide. They break when you are careless, Pulling apart rather than rotating the sections open. A bit of lubrication doesn't hurt either, but you must be careful not to over lube as the sections have difficulty staying straight. I have had a broken two section inside Lufkin that I have found very handy in the pocket while in the shop.

[Osvaldo Cristo]

I have and when I do, I have a folding yard stick.
If you are working wearing a nail apron, you can carry it in one of your apron pockets.
I find it to be very handy.
Then you have an excuse to go buy another folding rule. I like the 96" rules.

I just ran across mine.

Folding rule always was by far the most common rule in Brazil for almost everything at its 2 m standard size. Also it has been used the tape rule, but the largest one with no automatic recoil and usually at the range of 20-30m.

The first one I broken was my father's one and it cost me a beating as I borrowed it without his consent. The second one was one of mine... I think it was poorly constructed and the articular joint broken apart.

Currently I have just one in my workshop, 1 m long very useful for a range of applications - but my most used rules are two Irwin 5m Professional tapes.