OK this is a little tricky, but I figured I'd ask here while I continue to wait on ULS to answer. So over the past few months I have been working ULS on getting a replacement power supply for our PLS 360. The first one they sent was incorrect, and then we found out that he old Power supplies were phased out and are no longer available. Anyway then they sent us what they call and upgrade kit and the new supplies came in. They look similar but are different in a few ways. So I was able to wire one side that was actually labeled, but the other side that is in the picture was not. I'm trying to determine which wires go in which locations, based on a zoomed in picture they sent it isn't exactly the same as was on the old supplies. If anyone has ideas please let me know.