Results 1 to 1 of 1

Thread: Minimax CU300 crosscut fence to blade alignment at 45 degree blade tilt

  1. #1
    Join Date
    May 2005
    Location
    So Cal
    Posts
    866

    Minimax CU300 crosscut fence to blade alignment at 45 degree blade tilt

    My crosscut fence is perfectly aligned square to the blade when the blade is in normal cutting position of 90 degrees to the saw table. However, when I tilt the blade to 45 degrees for miter cuts, my crosscut fence is no longer square to the blade. What are the steps / adjustments on this machine to correct this alignment problem?
    Last edited by Frank Martin; 03-11-2019 at 1:08 AM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •