I can't seem to get this machine set up properly in gravostyle 98.
Its a New Hermes Vanguard 3200 with EP module, and it engraves just fine from the older DOS based program that came with it.
I just bought a used Gravostlye 98 pkg with dongle.
I installed everything according to the instructions in the manual.
The tool is set to the diamond drag in the tool selection box.
I thought I had set up the 3200 properly, and in the machining window the test run goes fine, the preview looks fine, but when I send the file to the machine, the EP module displays a series of messages "VALUE TO LARGE" and the cutter head starts jogging to the right until it hits its limit switch.
Under the printers dialog box in windows, I do have the GENERIC/TEXT driver and do have the spooler setting to RAW as stated in the manual.
My machine is a center clamping machine and in the machining window I do have the center clamp icon checked (I have tried the others and still have the same issue)
On the EP module the origin is set to X=6 Y=4.
This was so the old DOS program could find the origin.
Should the origin point on the EP module be set differently when using Gravostyle?
I have already spent hours on this and just can't figure it out.
SL734314.jpgSL734312.jpgSL734317.jpg