Contributor
With the Lee Valley kit no frame is needed. The opening however is 8” minus the wood jaws so probably a bit less than 6” of opening. My frame design opens a full 13” with no droop, which effectively makes the bench over a foot longer when needed.
Did the Lee Valley vise not come with plans?
You can do a lot with very little! You can do a little more with a lot!
[OP]
Member
https://www.finewoodworking.com/memb...6d3144575a749e
Here the link I found on the install. I’ve had it about 2 years but the problem was original I built just a touch out of square. So when you clamp anything long or cross grain it jumps out of the dogs. So I that why I’m rebuilding it.
Posting Permissions
Reply With Quote