Lets say I have plenty of floor space.
Typical 10" left tilt cabinet saw w the factory cast ext wings.
Currently 52" Biesemeyer setup.
May turn into R/D 12/14 but still w a 52" to right Bies.
So that is R tilt, but I will never be cutting matl wider than 6" at any blade bevel angle.
New shop... TIREDDDD of needing second person w stock hanging in the air.. at infeed, to the left side, and outfeed.
I want to be able to concentrate on staying against fence... NOT be distracted by fighting gravity.
Some 4x8 panel work... I have the floor space to permanently setup for ocassional sheet goods.
Rarely cut anything over 8' long.
Most often ripping stock 2' wide and MOST usually 8" or less.
** Have PLENTY floor space room for permanent tables.
Happy w my saw, not gonna spend 1000's on any slider.
So.. gonna build ext tables of interior door cheap slabs from big box w pipe "Floor Flange" legs w 1" EMT w steel setscrew connectors.
I have some ideas.. such as the infeed movable for operator belly room on the Bies angle iron infeed.. but asking here for opinions.
Googling and Youtube in meantime.
This must have been covered previously, but have not really found enough ideas yet.
Marc