Hello,
I have the 19-38 drum sander. I love it.
I bought the infeed and outfeed tables ... however, I can’t get them to be high enough to be level with the conveyer ...
Either the tables need to be higher, or the conveyer needs to be lower. (if there’s a third option, don’t tell me, my brain couldn’t handle it)
FYI, the drum head is parallel to the conveyer ...
I’ve tried “raising” the tables as much as possible (where it attaches to the matchine with two bolts, and the 4 bolts on the side of the tables), but I can’t get the table level ... at best, I can get only the very end of the table level (the end closest to the conveyer,) but the rest of the table angles down ...
If there were a way to lower the entire conveyer, that would work, but I can’t find that ... only where I can lower the one side (to make it parallel with the drum...)
I’m doing something wrong! I just don’t know what... anyone have any ideas?
Thanks
Matt