Hi all,

We've been reading Sawmill Creek for months and have learned a wealth of information, and for that, we thank you all.

Something that just happened today, Monday of all days, is an error in the EzCad program that will not allow us to operate. Getting this error - Fiber Laser: over temperature. No alarms, no signs of overheat. Ambient temp is 60F in the shop. All fans working. The machine is has been in operation since October 25th. It's a 30W, High Speed Galvo (sino-galvo). We cannot figure out what may be causing this error. We've messaged support but don't expect any reply for hours, or days.

Does anyone here have any experience or direction to point us in?

IMG_20190204_132344.jpg

Thanks!

Paul