So I was happily tiling my risers and getting ready to put the treads down. The profile of my side skirt is making the width narrower and I am unable to lift up the tread jig. It's stuck!!
Can someone offer suggestions on how to deal with this?
I tried to slide it down all the way to the bottom, but some middle steps are narrower than the ones from the top.
If removing the skirt (which is very difficult at this stage), how can I make measurements?
What a bummer!!! Being thinking hard, but can't find a solution except cutting the treads a bit narrower and leave an ugly gap on both sides.
Thanks much