Same bearings. Did you try 140W synthetic lube?
Same bearings. Did you try 140W synthetic lube?
Gary Campbell
CNC Replacement & Upgrade Controllers
Custom 9012 Centroid ATC
No, I never could find any 140W. All the hoses seem to go dry between uses and to get the oil to all of the bearings it just takes so many pumps and then the shorter runs start dripping. It is just such a mess that I thought maybe changing to grease and manually loading each bearing would be better. It gets annoying to think you have it all stopped and then in the middle of cutting something oil drips on the project.
That is because they probably did not install orifices into the feed lines. Using your pic from this thread (below) you can see the fittings circled in red. The blue arrow goes to a metering fitting, with an orifice, number on the side, telling its size. There are formulas online to set the proper size based on bearing type, distance, viscosity of lube, etc. I get the 140W synthetic at NAPA
Lube Manifold.JPG
Gary Campbell
CNC Replacement & Upgrade Controllers
Custom 9012 Centroid ATC
Gary, do you know what brand oil that is? I have checked a few stores the last couple of days and looked at NAPA online but am not seeing a synthetic in 140W.