In the last couple of years or so, when I buff turned objects, I am getting a lot of "buff fluff" on the piece. The buff generates a lot of static that holds the buff fluff to the surface. It wipes right off, but still leaves some small traces of fluff that are hard to remove. It is terrible for pictures. My question is: Is this normal? Does it happen more with some finishes than others (I usually use lacquer)? Is there a way to ground the buff so there is not so much static? When I started buffing, I heard that it is easy to get too much Tripoli etc on the buff. If anything I don't use enough. Don't know if this would have anything to do with it or not. Any Ideas?