Evening, all. Working on this blanket chest and I didn't get the case quite square. You'd never know by looking at it until the molding is attached.
THe plan was to build the plinth so that it extended 9/16" past the case on all sides then a 1/2" cove molding would be applied leaving a 1/16" reveal between the edge of the molding and the edge of the plinth. The plinth is square.
With the case set on the plinth so that the front has an even reveal since it will be most visible, the right & left sides are the problem. Right side reveal is ok at the front but increases at the back. Left side is also OK at front but decreases at back.
I've tried finagling the case on the plinth to reduce the error on the sides but then the front & back get messed up.
Any tips or tricks to hide or minimize this?