Another odd one coming up. We are machining a 36" x 36" brass floor medallion for a newly constructed fire station. Brought in a 36x36x1/4" thick plate of C260 and they shipped us a couple of small drops to play around with. Going to be milling out the graphic and mounting holes for some 1/2-13 brass machine screws in the four corners and then flooding the milled pockets with opaque red epoxy level with the surface.
Just uncrated the sheet and did a quick sand and polish, marked the few spots that are deep enough to need a little more attention then we will mask it, machine, epoxy, strip the mask, and re-mask to protect during install
20190119_141303.jpg