Results 1 to 4 of 4

Thread: Delta 36-450 Table Saw

  1. #1

    Delta 36-450 Table Saw

    I have a Delta 10" table saw, model 36-450. I misplaced the arbor nut wrench, and when I went to order another (along with a starting to round out arbor nut) I found the parts and many others were not available. Also, what is the size of the arbor nut? I think it's 15/16. The arbor nut is on the right side and is NOT a left handed thread.

  2. #2
    Join Date
    Jun 2012
    Location
    New Westminster BC
    Posts
    2,953
    If you have the old nut why not just take it into Lowes or Home Depot and match it up, pick up a matching wrench while you are at it?

  3. #3
    Join Date
    May 2014
    Location
    Alberta
    Posts
    2,162
    I bought a couple of arbor nuts off the bay from a guy who makes them,just go under "Unisaw". As for the wrench ,should be real easy to find in a pawn shop . The replacement nuts are wider than the original and have fit every Uni that I have tried them on. Mike.

  4. #4
    Join Date
    Nov 2003
    Location
    Central North Carolina
    Posts
    1,830
    You will find that the threads on a Unisaw are not standard threads, so a nut from the hardware store will not fit. The thread is a type of ACME thread. Most, if not all, Delta Unisaws and Delta Contractor saws use the same nut for right tilt saws. The left tilt all use a version for them. The special thread is the reason why they are so expensive and hard to find.

    Charley

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •