So, I just set up my new Grizzly G0833P (I initially was going to go with a SS, but decided on a diff route in case you read an earlier post of mine and are now confused) and am getting it all dialed in now. I have it level left to right dead nuts on from the center table out both the left and right extension wings. I have it mounted on a mobile base and in order for me to get it level front to back, I have to adjust the leveling feet on the mobile base so much that when I "flip" the casters down to move it, I can't because the leveling feet are too far out. Any advice?
Thanks,
Kevin