This was a pretty complicated glue up and I had to work very quickly. I built an entertainment center. The sides are not square to the bottom. I have two stiles/rails at the bottom that attach to the sides via mortis and tenon. There’s a handful of dado joints throughout the rest of the build. I must have really monkeyed down on the pipe clamps and pulled it out of square. By the time I realized it, it was too late.

I used titebond 3. I glued it up yesterday afternoon. Question is, if I use a heat gun to loosen up the glue on these joints do you think I will be able to pull it back to square without a complete disassembly? I couldn’t find any info on how the glue will me affected after being subjected to a heat gun. This is super frustrating as I have a lot of time invested in this project.