Hi everyone.
I recently got a new plunge router with an edge guide, but I'm not sure how to safely mill a groove in small dimensions of plywood.
I'd like to make a small tray, so I need to put a groove along the bottom of the pre-cut walls for the base.
routing_groove_in_small_piece.png
If it was a long peice, I could presumably clamp it parallel to the edge of a table, to run the edge guide along.
But because it's so small, I have no room for clamps.
Can anyone help me out?
Do I need to surround it with some sacrificial wood? Is there a better way to route small pieces without a table router?
Thanks!