Results 1 to 6 of 6

Thread: Bushing for 5 mm drilling

  1. #1

    Bushing for 5 mm drilling

    Having trouble finding a bushing for a 5 mm bit- or perhaps just not using the right keywords or just not sure what size bushing to get.

    I need to make a template for some repeated drilling that would place 5 mm holes around the corners of a square template, so I need only 4 bushings to place in the template. Can someone let me know what size would work without binding the bit and providing good accuracy? A source would be even better.

    As a side note the size could be slightly larger or imperial if it's easier. Up to 3/8 inch. I chose 5 mm simply because I have that bit already. I see some dowel drilling guides that have a bushing and bit, but they of course only have one bushong and I need the 4.

  2. #2
    Join Date
    Mar 2003
    Location
    SF Bay Area
    Posts
    187
    Lee Valley sells them. Here is a link: http://www.leevalley.com/us/wood/pag...at=1,180,40089 -Howard

  3. #3
    Thank you Howard! I should have known to look there first.

  4. #4
    Instead of a drill, why not use a plunge router with template bushing. Make a master for router that has oversized holes that you template bushing would fit into. Fasten on desired piece, and using plunge router drill holes.

  5. #5
    McMaster has them too.

  6. #6
    Have you considered an aux. table on drill press, with V shaped fence? Each corner of piece to be drilled would fit into fence the same way. Fifty cent solution to a $500 problem.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •