My new shop made miter station

[Steve Reich]

Tommy:

A picture of the inside isn't going to reveal much of anything because the hardboard covers everything that would reveal how I attached the box/hood to the torsion box. So there's a torsion box on each side of the saw; on those sides I glued and screwed in a cleat (I think about an inch wide); I then put the side of the box up against the cleat and pocket screwed it into the torsion box. The back of the box screws into the work bench and has a little notch at each end that brings it up over the torsion box to meet the two sides. Hope that makes sense.

[Thomas Crawford]

Thanks Steve, that makes sense. Hoping to get my station started later this month.