Hi,
I have a New Hermes 3400 and need to replace the spindle belt (O Ring).
Does any one have any guidance on this procedure. I have received the replacement belt from Q1.
Thanks
Hi,
I have a New Hermes 3400 and need to replace the spindle belt (O Ring).
Does any one have any guidance on this procedure. I have received the replacement belt from Q1.
Thanks
TROTEC Laser, Roland SP300,SAWGRASS SG1000 Sublimation Printer, Q1 Mod New Hermes Vanguard 3400 Engraver, Daige Laminator, Next Wave Shark HD510 CNC
The spindle resides in a carrier that rides up and down 2 SS rods, the left rod is almost directly behind the spindle. Where the rod goes into the main carrier housing, towards the top you'll notice an allen screw in the housing, this holds the rod in place. There's another screw at the bottom, behind the spindle, so you need to remove the spindle from the carrier to access it. Loosen both screws and back them out quite a ways, just not all the way out. Directly above the rod is a hole in the housing, just large enough for a cutter tool or small screwdriver to fit-- Now, with a small hammer and your tool or screwdriver, just tap the rod downwards until it's out of housing enough to get the belt past. Fit the belt in, the tap the rod back up into place from below and tighten the set screws. Run the belt under the black 'drive wheel' or whatever it's called, put the spindle back in place then put the belt on.
========================================
ELEVEN - rotary cutter tool machines
FOUR - CO2 lasers
THREE- make that FOUR now - fiber lasers
ONE - vinyl cutter
CASmate, Corel, Gravostyle
Thank you very much Kev for the detailed instructions!
I just completed the replacement.
Thanks again!
TROTEC Laser, Roland SP300,SAWGRASS SG1000 Sublimation Printer, Q1 Mod New Hermes Vanguard 3400 Engraver, Daige Laminator, Next Wave Shark HD510 CNC
no problem, got 4 of the things, I can change the belts in my sleep- even that long one
========================================
ELEVEN - rotary cutter tool machines
FOUR - CO2 lasers
THREE- make that FOUR now - fiber lasers
ONE - vinyl cutter
CASmate, Corel, Gravostyle
Installing that belt Always reminded me a little of what Rube Goldberg's mind must be like:
I can relate, lol...
While I'm not much of an inventor, I AM pretty good
at making do with what I got handy!
-laser engraving I did of PART of my shop-
TheAbyss(custom).jpg
(about 5 years ago, it ain't got no better either!)
========================================
ELEVEN - rotary cutter tool machines
FOUR - CO2 lasers
THREE- make that FOUR now - fiber lasers
ONE - vinyl cutter
CASmate, Corel, Gravostyle
Looks like a fun place to be